Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EXTENSION CORD. Make sure your extension cord is in
good condition. When using an extension cord, be sure it is
heavy enough to carry the current your product will draw. An
undersized extension cord will cause a drop in line voltage
resulting in loss of power and overheating. The following
table shows the correct size to use depending on cord length
and nameplate ampere rating. If in doubt, use the next
heavier gage. The smaller the gage number, the heavier the
cord.
Minimum Gage for Cord Sets
Volts
Total Length of cord in Feet
120V
0-25
Ampere Rating
More Not More
0
-
6
18
6
-
10
18
10
-
12
16
12
-
16
14
WARNING: Use out door extension cords marked SW-A,
SOW-A, STW-A, SJW-A, or SJTW-A. These cords are rated
for outdoor use and reduce the risk of electric shock.
DOUBLE INSULATION—Double Insulation is a concept in
safety in electric power tools, which eliminates the need for
the usual three-wire grounded power cord. All exposed metal
parts are isolated from the internal metal motor components
with protecting insulation. Double insulated tools do not need
to be grounded.
NOTE: The double insulated system is intended to protect
the user from shock resulting from a break in the tool's
internal insulation. Observe all normal safety precautions to
avoid electrical shock.
It is possible to tie the extension cord and
power cord in a knot to prevent them from
becoming disconnected during use. Make
the knot as shown, then connect the plug
end of the power cord into the receptacle
end of the extension cord,. This method can also be used to
tie two extension cords together.
26-50
51-100
101-150
American wire Gage
16
16
14
16
14
12
16
14
12
12
Not Recommended
POLARIZED PLUGS—To reduce the risk of electric shock,
this equipment has a polarized plug (one blade is wider than
the other). This equipment must be used with a suitable
polarized 2 wire or 3 wire extension cord. Polarized
connections will fit together only one way. Make sure that the
receptacle end of the extension cord has large and small
blade slot widths. If the plug does not fit fully into the
extension cord, reverse the plug. If it still does not fit obtain a
suitable extension cord. If the extension cord does not fit fully
into the outlet, contact a qualified electrician to install the
proper outlet. Do not change the tool plug or extension cord in
any way.
CHECK DAMAGED PARTS – Before further use of the tools,
a guard or other part that is damaged should be carefully
checked to determine that it will operate properly and perform
its intended function. Check for alignment of moving parts,
binding of moving parts, breakage of parts, mounting and any
other condition that may affect its operation. A guard or other
part that is damaged should be properly repaired or replaced.
Call our customer service help line at 1-800-313-5111 for
assistance.
WARNING: California Proposition 65: This product contains
chemicals known to the State of California to cause cancer,
birth defects or other reproductive harm.
WARNING: Some dust and debris created by this tool could
contain chemicals known to the State of California to cause
cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
-chemicals in fertilizers
-compounds in insecticides, herbicides and pesticides
-arsenic and chromium from chemically treated lumber
Your risk of exposure to these chemicals varies depending on
how often you do this type of work. To reduce your exposure,
work in a well ventilated area and with approved safety
equipment such as dust masks that are specially designed to
filter out microscopic particles.
WARNING: Cancer and Reproductive Harm -
www.P65Warnings.ca.gov.
CAUTION: Never stand under the limb being trimmed.
Position yourself out of the way of falling debris.
4
Model CVPS43010
Tabla de contenido
Solución de problemas
