Rear Panel - Alto Professional RMX1508DFX Manual De Inicio Rápido

DSP (DIGITAL SIGNAL PROCESSOR)
28. EFFECTS SELECTOR – Selects the effect that the mixer's internal effects processor
will apply to the various channels. Each channel can send different levels of audio to
the processor by adjusting their Aux 2/FX Post knobs.
29. FX MUTE – Press this button to mute/unmute the effects.
30. VARIATIONS SELECTOR – Selects the amount of the effect applied to the various
channels.
31. Clip/Mute LED- This LED flashes when the signal input into the digital multi-effect is
too strong. When the digital effect module is muted, the LED also lights up.
32. FX TO MON- This is used to control the volume of the processed signal sent to Monitor
mix, which can be varied from - to +10dB.
33. FX TO MAIN- This is used to control the volume of the processed signal sent to Main
mix bus, which can be varied from - to+10dB.
34. FOOTSWITCH – When a latching-style footswitch is connected to this jack with a 1/4"
TRS cable, it can be pressed to allow all channels to bypass the mixer's internal effects
processor.

REAR PANEL

35. POWER SWITCH – Turns
the mixer on and off. Turn on the mixer after all input
devices have been
connected and before you
turn on amplifiers. Turn off
amplifiers before you turn
off the mixer.
36. POWER IN – Use the
included IEC power cable
to connect the mixer to a power outlet. While the power
is switched off, plug the power supply into the mixer first,
then plug the power supply into a power outlet.
check the voltage available in your country and how the
voltage for your RMX1508DFX is configured before
attempting to connect your RMX1508DFX to the main
AC.
37. SPEAKER JACKS-
speakers. They are configured with 4-way Speakon
connectors and 1/4" phone jacks. You can determine the
signal that is output to these jacks according to the setting of the AMPLIFIER MODE select switch.
Note: In order to avoid damage to the built-in amplifier, please pay attention to the allowed impedance
of the speaker. Very low load impedances may damage the amplifier. Look at the plate on the back of
your unit for reference.
!
Caution: Do not connect the rear panel speaker level ¼" outputs to anything other than a passive
loudspeaker. Connecting this output to a line line/Mic level input may damage your equipment.
35
36
These jacks are used to connect
* WARNING: Units bought in the US are
preset to US voltage. Units purchased in
Please
EU/UK are preset to 220/240 voltage.
Adjustment should not be made unless
you're traveling to other countries or are
in a
Selecting an improper voltage can damage
the unit.
5
28
29
30
32
0
33
0
FX TO MAIN FX TO MAIN
FOOTSWITCH FOOTSWITCH
34
country with varying
31
10
10
37
37
voltage.