Idiomas disponibles
Idiomas disponibles
Use this (on RS485 connection) when the distance of the data cable is near or over 100 m / 328.08 ft and the
J6
J9
J7
J14
DATA 2 / CLK2
DATA 3 / CLK3
DATA 4 / CLK4
Type: RFID TAG READER
EC type examination certificate: BKI 08 ATEX 0048
Type approved: GUB
Ex II 2 GD
Marking: Ex d IIC T6 ExtD A21 T85°C IP66
Homologation: ATEX (EN60079) & IECEx
Type approved: PAP-R0 M20
II 2 GD
Marking: Ex d IIC – Ex e II – Ex tD A21
Degree of protection: IP66 level
1
2-3-4
Inner sealing ring for armored cable
5
6
Armour clamping ring for armored cable
7
8-9
10
11
12
13
Chamber will be filled with sealing when cable gland is completed assembled.
*
ATEX & IECEX UHF reader
Installation procedure
TTL / RS232 / RS485 / I/O Connection
signal is weakened (polluted signals, frame errors etc.).
Micro USB connector for configuration purposes only
Use this connector for earth connection purpose
IN 1-2-3-4
OUT 1-2-3-4
V- opt
Low polarization potential of opto-coupled inputs and outputs
V+ opt
High polarization potential of opto-coupled inputs and outputs
DATA1
CLK1
ALIM
GND
Characteristics Flameproof Enclosure
Temperature: -20°C to +50°C / -4°F to +122°F
Connectors:
Cable gland body
Armour clamping cone
Gland barrel
Internal sealing ring
Anti rubbing washer
Cable gland head
O-Ring seal
*Chamber for sealing
© STid - 20 PA des Pradeaux FR13850 Gréasque – NI1145A01 - Page 2 sur 15 - Ed. 02/09/2020
Lecteur UHF ATEX & IECEX
Notice d'installation
End of line resistor RS485
TTL output level: +5V or Vin
4 opto-coupled inputs
4 opto-coupled outputs
Data or D0 Channel 1 or Tx (
RS232)
Clock or D1 Channel 1 or Rx (
Data/Clock or D0/D1 Channel 2
Data/Clock or D0/D1 Channel 3
Data/Clock or D0/D1 Channel 4
Power supply
GND
ATX:
2 cables glands PE PAP-R0 M20 for blinded cable 10-19 mm.
ATX4:
2 cables glands PE PAP-R0 M20 for blinded cable 10-19 mm.
4 Isolate-CT Ex d N-type / SMA female RF for antennas
connection.
Characteristics Cable gland
Ø internal
Ø external
Thread C
ATEX & IECEX UHF lectores
Manual de instalación
or L+ (
RS485)
L- (
RS232) or
RS485)
Min
4 mm / 0.157 in
10 mm / 0.394 in
ISO: M20
US
FR
ES
Max
10 mm / 0.394 in
15 mm / 0.591 in
NPT: ½"
