Step-By-Step With Automatic Reclosing Operating; Manual Step-By-Step With Stop Operating; Dip-Switch3 Function; Pre-Flashing Function - Hiltron security PCM100 Manual De Instrucciones

PCM100 / PCM130 - User Manual
3.1.3 STEP-BY-STEP WITH AUTOMATIC RECLOSING
With one pulse allows : opening, pause, automatic closing
During opening and closing procedures, every pulse stops and reverse the movement of the
gate immediately. During the pause, a pulse recloses the gate immediately.
GATE
PULSE A
STATUS
Total Opening and
reclosing after the
CLOSE
time of pause
The opening is stopped and the next pulse
OPENING
OPEN
IN PAUSE
It is locked and only a new pulse recloses
CLOSING
Restarts the operating procedure before
IN STOP
3.1.4

MANUAL STEP-BY-STEP WITH STOP operating

One pulses opens; the next pulse stops; the next pulse closes ; the next pulse stops; the
next pulse opens, etc ..
GATE
PULSE A
STATUS
Total Opening
CLOSE and STOP at the
end of course
The opening is stopped and the next
OPENING
OPEN
Reverses the movement of the motor
IN PAUSE
The closing is stopped and the next
CLOSING
Restarts the operating procedure before
IN STOP
3.1.5 Function DIP-SWITCH 3
Below are the tables related to the position of the dip-switch 3
ON
PHOTOCEL. 1 FOTOCELL. 1
SW3=OFF SW3=OFF
CLOSED CHIUSO
IN APERTURA IN OPENING
IN CHIUSURA IN CLOSING
3.1.6

PRE-FLASHING Function

The pre-flashing function notifies in advance the movement of the gate. In the case of a flashing light attached to the
center automation, this will start to flash for about 2 seconds before starting any operation.
28
PULSE B
Partial Opening and
closing operation after
the time of pause
recloses the gate
Recloses the gate immediately
the gate
the STOP (closing or opening)
PULSE B
Partial Opening
and STOP at he
end of course
pulse recloses the gate
pulse opens the gate
the STOP (closing or opening)
PHOTOCEL 2 FOTOCELL. 2
No Effect
No Effect
Stops operation and reopens the gate
immediately
STOP PHOTOCEL.1 PHOTOCEL.2
Disables A and B pulses
and disable opening
Stops operation and
The reclosing is stopped and at the end of
switches to STOP
the pause, it restores other 5 sec. up to the
mode
The pulses A and B will be ignored.
The opening or closing operation are locked
Remain in STOP. The pulses A and B will be ignored.
The opening or closing operation are locked
PHOTOCEL.1 PHOTOCEL.2
STOP
Disables A and B
pulses and disable
opening
Stops operation and
switches to STOP
mode
Stops operation and the gate opens
Remain in STOP. The pulses A and B will be ignored.
The opening or closing operation are locked
SW3=ON SW3=ON
CLOSED CHIUSO
IN APERTURA IN OPENING
IN CHIUSURA IN CLOSING
(SW1=OFF- SW2=ON)
See SWITCH 3 pages 9 and 10
See switch 3 page 10
(SW1=ON - SW2=ON)
See SWITCH 3 pages 9 and 10
See switch 3 page 10
Pulses A and B are ignored and all
movement are locked
immediately
PHOTOCEL. 1 FOTOCELL. 1
ignores pulses A and B and remains closed
Stops operation with flash on and waits for
realignment of the photocells before returning
to the opening
Stops operation and reopens the gate
the realignment of the photocells
security
ON
ON
DIP1
ON
PHOTOCEL. 2 FOTOCELL. 2