Tabla de contenido
1347D Sewing Head Parameter List
PARAMETER
RANGE
Do this first
*****
290
026
0-5
111
200-9900 rpm
119
1-3
161
0-1
240
0-31
270
0-5
272
020-255
436
Front panel LED's:
LED 1: Off
LED 2: Off
LED 3: Off
LED 4: Off
LED 5: Off
LED 6: Off.
LED 7: OFF, Stop at needle down.
LED 8: ON, Stop at needle up
SUGGESTED/
SHIPPED/
VALUE
VALUE
****
5
0
350
1
1=CCW
6
1
90
0
0
11347D PARAMETER DESCRIPTION (SEWING HEADS)
Perform a master reset before programming, see below
Mode (Chainstitch) of operation. MUST SET THIS PARAMETER
FIRST!
F-026=0 to disable the EB401 selection after power on.
Maximum speed when "129" is 0, 1, or 2.
Linear Acceleration
Motor Rotation
Machine run blockage with open contact
External Hand Wheel Sensor Configuration.
Drive ratio between motor pulley and handwheel pulley. If handwheel
pulley is smaller than motor pulley, increase this value to slow down
sewing head until measured speed matches speed set with
parameter 111. (For Yamato and Pegasus, setting should be 100; for
Rimoldi, setting should be 124)
Use code "5913". This disables an input that was causing box to
reset itself.
Programming Instructions:
1. Power on holding down the "P" button till "COD" is displayed.
2. Press ">>" once and enter the number "311"
3. Press "E" once and "2.0.0." is displayed this is a parameter
4. Proceed to the parameter to be changed and press "E".
5. The value now shows in the screen, adjust to desired value.
6. Press "E" to enter value and continue with parameter setting.
7. Repeat for other parameters, press "P" once when complete.
8. Run sewing head to save parameters before powering down
To Perform Master Reset of Parameters:
1. Power on holding down the "P" button till "COD" is displayed.
2. Press ">>" once and enter the number "591"
3. Press "E" twice and "093" is displayed.
4. Press "+" once, "094" is displayed.
5. Press "P" to exit programming mode with all default values.
Manual Técnico & Lista de Partes
22
Tabla de contenido
