Siku CONTROL 1:32 Manual De Instrucciones página 10

The control module
This SIKUCONTROL model can only be operated
when using the corresponding SIKU Remote Control
Module (Part No. 6701). The module operates on the
basis of infrared light. According to present day
knowledge, no danger to health exists when using
this model in the correct way as described in
these instructions. The way to use the various switches
is described on the following pages. The batteries
necessary to operate the module (4 x Battery Type
AA) are not included and must be purchased before the model can be used. Please be careful to
check the right position of the batteries as is shown
on the base of the battery case. The module should
only be used in a dry room and be protected against
dust and moisture. Clean if necessary only with a dry
cloth.
Instructions regarding the batteries for
the Module. The SIKU Remote Control Module
must only be used with Type AA batteries. Check
these regularly to make sure they are not starting to
12
leak. Always remove empty batteries from the
module. Remember, non rechargeable batteries
cannot be recharged! This must always be
carried out by an adult.
Remember to place the batteries in the case with the
right polarity. Different battery types or new and old
batteries must not be used together. Using
rechargeable batteries can lower the transmitting
power of the module. Do not throw old batteries into
the household rubbish bin. Please pay attention to
your local rubbish disposal regulations!
More SIKUCONTROL models are being added to
the range. The additional control knob as well as
other switches not described further in this manual
are reserved for functions on future models. It is
possible that some switches already in use for current
vehicles can have other functions on future models.
Choosing the Channel on the Module
Now switch on the module by pressing the SIKU
button. This will flash red. Within the next 5 seconds
choose the same channel number you have chosen
for the tractor and press the corresponding switch on
the module.
Both the SIKU button switch and the selected channel
switch will then light up permanently.
Choosing the Channel on the Tractor
Before switching the tractor operating switch on,
choose one of the four channels available by turning
the switch found underneath on the chassis of the
tractor to the channel number you want to use.
The Speed Control
The speed is controlled infinitely by pressing the tip
switch on the rear left-hand side of the module. To
return to the stop position just let go of the switch.