Troubleshooting - Black+Decker PR100SD Manual De Uso Y Cuidado

TR O U B L ESHO OTI NG
PROBLEM
Difficult to
close the lid
Difficult to
open the lid
Steam leaks
from the side of
the lid
Red float valve
unable to rise
Steam comes
out from the
exhaust valve
without stopping
Display flashes
"OPEN"
POSSIBLE CAUSE
Rubber gasket not installed
properly
Red float valve in the
popped-up position
Pressure exists inside the
cooker
Red float valve stuck at the
popped-up position
Rubber gasket not in place
Rubber gasket damaged
Food debris attached to
the rubber gasket
Lid not closed properly
Not enough food or water
in the cooking bowl
Red float valve is
obstructed by the locking
lid pin
Lid is not in the seal
position
Pressure control fails
Lid is not at the correct
position for the selected
program
19
SOLUTION
Check the position of
the rubber gasket
Press the red float
valve downward
lightly
Use the pressure
release valve to
reduce the internal
pressure. Open the lid
after the pressure is
completely released
Press the red
float valve lightly
downward with a
kitchen utensil
Install the rubber
gasket correctly
Replace the rubber
gasket
Clean the rubber
gasket
Open then close the
lid again
Add water according
to the recipe
Close the lid
completely,
see "Operating
Instructions" section
Turn the pressure
release valve to the
seal position
Contact the
consumer service
team
Close the lid for
pressuring cooking
or open the lid for
browning