Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALLATION MANUAL
ECM5000 - ECM5000M - ECS5000 - ECS5000M - ECS8000 - ECS8000M
Surface mount or Mortice Electromagnetic locks
Terminal
Correspondence
block
+
12 or 24V dc
-
- 0 V
N.C
NC (Normally closed)
COM
COM
N.O
NO (Normally open)
The NO/NC signal only switches when the door
is closed with the power to it on.
WITH BUILT-IN PCB BOARD
ECS5000 - ECS8000
12V dc
ECM5000M
4
position.eu.com
ECS5000
ECS8000
ECM5000
-
-
-
ECS5000M - ECS8000M
Voltage
selection
jumpers
24V dc
ECM5000
ECS5000M
ECS8000M
ECM5000M
- Check the jumper position before connecting
the lock to the input current. A wrong position
could damage the lock. This type of damage
is not covered by the warranty.
- Make sure that the magnet and the armature
meet evenly over their entire mating surfaces.
The Armature plate must be able to pivot
slightly about its center mounting screw
to compensate for any door misalignment.
DIRECT CONNECTION
White
Green
Black
White
Green
Black
Yellow
Orange
IMpoRtaNt Note
12V dc Default setup
12V DC
Red
24V DC
Red
CONTACT
Blue
EN
+
-
+
-
NC
COM
NO
Tabla de contenido
