Getting Ready - Hkoenig ARYA600 Manual De Operación

GETTING READY

The mop pad may have already come attached to the mop pad tray on the foot
of the unit. If not, please follow step 1 below.
For Microfiber Mop pads, please follow these steps:
1. Attach mop pad
a. Step on foot release for mop pad tray and lift unit off tray
b. Some units may come with freshening discs. Add
freshening Disc in the mesh pocket in the mop pad. Use
the whole disc for a refreshing scent or cut in half for a
lighter scent.
c. Wrap mop pad around the bottom of the tray, making sure
the grey stitching is in the front and the quick release tab
is in the back.
d. Put the mop pad tray back down on the floor and set the unit back on
top. It will click into place.
2. Fill the water tank
a. On the back of the unit, open the Easy Fill opening of the
water tank and use the included water cup to fill the water
tank with water. Don't overfill or water may spill
from the tank. For best results, water should be at
room temperature.
b. Close the Easy Fill opening.
c. The water tank holds 384 mL and will last approximately 15
minutes depending on the amount of the steam used during cleaning.
3. Pull and twist the Quick Release cord wrap clockwise to unwrap the power cord
completely and plug into an outlet as described on the Important Safety Instructions
on page 2.
NOTE: Upon the first use of the ARYA600 or first use after refilling the water
tank, the pump may make a 'knocking' sound. This is normal and could last up
to 30 seconds.
Foot release