HIDROBEX XKS250P Manual De Instrucciones página 14

o If necessary, have it checked and repaired by an authorized centre (consult your
dealer).

INCIDENTS – CAUSES - REMEDIES
INCIDENTS
Pump does not start
No flow
Pump does not switch off
Insufficient flow
Pump switches off after short
operating period
CONFORMITY DECLARATION OF THE EUROPEAN UNION
We hereby declare that the equipment meets, both for its design and construction class and for the
execution that we have in circulation, the fundamental rules of safety and health protection contained in the
relevant EU directives.
This statement is void if alterations are made to the machine without our explicit approval.
Product : submersible pumps models XKS250P, WA350, EQS550, WB400, WB750, XKS550S,XKS750S,
XKS1100S, XKS750SW, XKS1100SW
Serial Number (see nameplate of the product conformity with the following directives :
2006/95/CE; 2004/108/CE
For verification of compliance, we have consulted the rules described below :
EN60335-1; EN60335-2-41; EN62233; EN55014-1; EN55014-2; EN61000-3-2; EN61000-3-3
Through a series of internal measures, it is assured that the devices always meet the requirements set out in
existing EU directives.
14
CAUSES
-No mains supply
-Floater does not switch
-Inlet filter is clogged
-Floater cannot sink down
-Inlet filter is clogged
-Reduced pumping capacity
-Thermal cutout stops pumps
due to dirty water
-Water too hot
Parets del Vallés 01-01-2013
REMEDIES
-Check mains supply
-Check floater
-Clean inlet filter
-Place pump properly on shaft
-Clean inlet filter
-Clean pump and replace
-Remove mains plug. Clean
pump and shaft.
-Make sure that the water
temperature its ok.