IntesisHome PA-AW-WIFI-1 Guida Rapida página 4

®
IntesisHome PA-AW-WIFI-1
®
4. IntesisHome device connection procedure
Before starting the set up process, make sure that the Air-Conditioning unit (AC) is connected to the power supply
®
line and IntesisHome LED is steady Green.
IMPORTANT: Please, make sure that you are close enough to the IntesisHome
confi guration process so your OS does not change the Wi-Fi network you are connected to. This may
cause unexpected behavior of the device during the confi guration process and a bad confi guration
result.
There are two connection modes available: with WPS and without WPS.
NOTE: Check your Access Point (AP) or router user's manual to fi nd (if available) the WPS button or
WPS activation procedure
4.1 Connection with WPS
This method assumes that your Access Point (AP) or router supports WPS connection mode.
1.- Press IntesisHome
2.- Activate your AP WPS mode. IntesisHome
®
IntesisHome device and the AP should perform the connection setup automatically. Please move to
section 4.3 of this document to verify that the result is as expected.
4.2 Connection without WPS
This method assumes that your AP or router does not support WPS connection mode and that you have a
Wi-Fi compatible device (laptop, mobile phone, tablet, etc.) Remember to stay close to the IntesisHome
device during all confi guration process.
1.- Connect your Wi-Fi device to the IntesisHome
(Network that starts with Intesishome)
If you are not able to see the Wi-Fi network, get
closer to the IntesisHome
2.- Open the web browser of your Wi-Fi device and
write ihconfi g.com on the address bar
®
(IntesisHome welcome site will open)
®
If IntesisHome
please press your browser refresh button and re-
start connection process from step 1.
4
® device button. IntesisHome
®
device LED will change blinking color.
® device.
welcome site does not open,
USER'S QUICK START GUIDE
® device LED starts blinking blue.
®
Wi-Fi network
® device during all
®