Operating Facilities; Remote Control; Power Requirements - Aim TTi TF930 Manual De Instrucciones

Operating Facilities

Noise Filter
The Filter key controls a low pass filter, with a cut-off frequency of about 50kHz, to assist in
obtaining stable readings at low frequencies.
Hold
Pressing the Hold key will hold the current measured value in the display, with the Hold indicator
on, until the Hold key is pressed again. The measurement continues in the background when
Hold is on. A long press on the Hold key clears old data and restarts the measurement.
Intelligent Power Switching
The unit automatically selects the best available power source of AC adaptor, USB or battery.
Intelligent switching avoids discharging the battery overnight when operated from externally
switched AC power.
A press-to-measure facility allows a quick measurement to be made by pressing a function select
key which will power the instrument up in the corresponding function. The instrument will
automatically switch off 15 seconds after the last key-press.

Remote Control

All capabilities can be controlled remotely and measurements read through a USB port.
The instrument can be powered (but the battery cannot be charged) by the USB host.
Interface:
Current consumption:
Command set:

Power Requirements

The instrument has fixed internal rechargeable batteries and is supplied with a universal voltage
external mains adaptor with interchangeable UK, Euro, Australian and US power connectors.
Battery Type:
Battery Operating Life:
Low Battery Indicator:
Recharge Time:
Adaptor Supply range:
Power consumption:
General
Display:
Operating Range:
Storage Range:
Environmental:
Size:
Weight:
Safety & EMC:
4
Serial port emulation over USB.
< 95mA (<5mA if AC adaptor power is present)
Instrument specific. TF830 compatible.
Three 2500mAh NiMH cells.
Typically 24 hours
'Lo Bat' shows in display when approximately 10% of battery life remains.
< 4 hours
85 to 240V, 50 or 60 Hz,
5W max at DC input to unit; 15VA max at AC adaptor input (charging).
10 digit LCD, 12.5mm high (0.5"). Annunciators show input configuration,
operating mode, measurement units and gate time.
+5°C to +40°C, 20% to 80% RH
20°C to +60°C
–
Indoor use at altitudes up to 2000m, Pollution Degree 2
260mm(W) x 88mm(H) x 235mm(D)
950 gms (plus 170 gms AC adaptor)
Complies with EN60950-1 & EN61326-1.
For details, request the EU Declaration of Conformity for this
instrument via http://www.aimtti.com/support (serial no. needed).