Foreword; Unpacking; Connection; Instructions For Installation - Dru Verwarming FIRE COUNTRY RC Manual De Instalación Y Guía Del Usuario

INSTRUCTIONS FOR INSTALLATION

Foreword

Dear Customer,
We would like to thank you for buying this DRU product.
Our products have been designed and produced to meet
the highest possible quality, performance and safety
requirements, allowing you to enjoy years of problem-free
use. This DRU product is ideal as a decorative fire in an
open hearth or fireplace and not intended to heat an
entire room.
In this booklet you will find instructions for the installation
and use of your new log fire. Please read these instructions
and the manual carefully to familiarize yourself with the
appliance. If you require any further support, please do
not hesitate to contact your supplier.

Unpacking

Once the heater has been unpacked, all packaging should
be disposed of in the regular manner.

Connection

This appliance should be connected by a registered
installer.
INSTRUCTIONS FOR INSTALLATION

Type of gas

This appliance can only be used and is only suitable for the
country and the type of gas mentioned on the type identi-
fication tag. Please check that the local gas and pressure
correspond with the specifications on the type identifica-
tion tag.This tag can be found on the inside of the frame
of the Fire Country. The Fire 30 and Fire 50 have a chain
with a metal type identification tag. All regulations regard-
ing gas installation, including any local regulations, must be
observed at all times. The appliance is to be installed by a
registered installer.

Important

• Keep curtains and any other flammable materials at least
50cm away form the appliance.
• Caution! Touching the heater when hot can cause burns
and blisters!
• The appliance should be installed and maintained by a reg-
istered installer.

Positioning the fire

• The gas fire may only be installed in a well-ventilated room
allowing a constant air supply.
• The appliance is suitable for installation in a fireplace or
hearth made of incombustible materials only.
• The minimal dimensions for the fireplace or hearth are
645x345 mm for the Fire Country, 500x300 mm for the
Fire 50, and 400x300 mm for the Fire 30.
• The weight of the Fire Country is 19 kg.
The weight of the Fire 30 and Fire 50 is 6 kg.
• The minimal height of the flue duct is 600mm.
• The chimney must be at least 200 mm in diameter.
• A flap or chimney damper, or any other kind of obstacle
present, should be removed.
• The centre of the appliance must be no more than 60 mm
from the centre of the flue duct.
• The chimney must be swept before the appliance is
installed and the flue duct must be tested in accordance
with national guidelines.
Ø 202 (inw)
650
677

Installing the Fire Country

The Fire Country is intended for installation in a new fire-
place using in an existing fireplace without a grate
(principle according to fig. 1).
An inset box can be ordered from your installer.
• Remove any unnecessary ornamental fireguards as
required so that the appliance can be fitted in the left or
8
118
346
453
38C-755
fig. 1
fig. 2