Environment Protection - Truper HIDR-1/2X24 Manual De Instrucciones

PROBLEM
The pump is not
running.
The flow rate is low.
There is not enough
pressure.
The pump cannot be
shut OFF.
Environment
protection
How to dispose off
Utensils labeled with this symbol
discarded with domestic trash. They shall be disposed off
separately with electric and electronic devices.
Ask the local authority to learn the right way to dispose off
devices.
When separating waste you are sending old devices to be
recycled or to use them in a different manner. Also it is the
safe manner to prevent harmful materials to damage the
environment.
To discard the packaging
Packaging is made of cardboard and plastic labeled as
recyclable.
- Please recycle this materials-
8
CAUSE
- There is no power.
- Motor is overheating due to the
liquid's high temperature.
- Motor is overheating due to sealed
ventilation slots.
- The residual current protection switch
(FI Switch) is activated.
- Defective Motor.
- Water shortage.
- The suction tube is not sealed.
- Suction height is too high.
- The filter is blocked or has sand.
- The check valve is blocked.
- There is water leaking between the
motor and the pump. The drawbar
seal is not the right one.
- The pump is blocked or is defective.
- There is air in the pump or the suction
pipe.
- The pressure switch is not adjusted.
- The suction pipe is buried into the
ground.
- Cutting pressure is too high.
- The suction side is not sealed.
shall not be
SOLUTION
- Inspect power cord, plug and fuse.
- Liquid maximum temperature shall
be 95 ºF
- Eliminate what is causing
overheating.
- Turn on the FI switch. If it fails again
go to a Truper Authorized Service
Center.
- Go to a Truper Authorized Service
Center.
- Double-check there is enough water
supply.
- Seal the suction pipe. Tighten the
threaded connections.
- Verify the maximum suction height.
(Technical Data). Suction height
shall be subtracted from the pumping
height.
- Clean or replace filter.
- Clean or replace valve.
- Go to a Truper Authorized Service
Center.
- Clean the pump with clean water and
remove the cause of contamination.
- Fill up the pump receptacle with
water. For pipes with check valve,
fill-up the suction pipe with water.
- Go to a Truper Authorized Service
Center.
- Shorten or fasten the suction pipe.
Use a filter screen with check valve.
- Go to a Truper Authorized Service
Center.