Technical Data - DAY 70051 Manual De Instrucciones

10 CHRISTMAS TREE LIGHTS WITH REMOTE CONTROL
Introduction
To get the most out of your new LED
Christmas tree lights, please read through
these instructions before use. Please also
save the instructions in case you need to
refer to them at a later date.

Technical data

10 × Christmas tree lights:
Battery: 1 x 1.5 V AAA batteries per light
(Total 10 x 1.5 V AAA batteries, not included)
Remote control:
Range:
For indoor use only!
Use
Unscrew the base of a Christmas tree light.
Insert 1 x 1.5 V AAA battery. Check that the
battery is correctly fi tted. Screw the base
back on.
Repeat this procedure for all 10 lights.
10
Ø1.7×15 cm
1 × CR2025 battery
(included)
approx. 5 meter
Place the Christmas tree lights on the
branches of the Christmas tree using the clips
at the bottom of the Christmas tree lights.
If you take the clips off the lights, they can
be used in all common holders for Christmas
tree lights.
Press the ON button on the remote control to
turn all the Christmas tree lights on at once.
If not all the Christmas tree lights turn on,
move closer with the remote control.
Press the OFF button on the remote control
to turn all the Christmas tree lights off at
once.
The built-in LEDs in the Christmas tree lights
cannot be replaced but have a long service
life.
If the lights grow weak, the batteries need
replacing.
If the range of the remote control reduces,
replace the battery in the remote control.
Remove the batteries if you do not intend to
use the Christmas tree lights for a prolonged
period before putting them into storage.