Start Up - Truper CEP-12 Manual De Instrucciones

Adjustments
Depth Scale Adjustment
• Feed a piece of scrap wood to plan (see page 10).
• Compare the measured thickness in the planned piece
with the reading in the cutting depth scale.
• If there is no match, loosen the scale guide screws (G)
and adjust to the thickness measurement in the planned
piece.
• Test again using another piece of scrap wood and, if
necessary, repeat the procedure until the measurement
indicated in the scale guide matches the planned piece
thickness.

Start Up

Turning ON
• The planer is built with a switch (H) with a safety key
(REMOVE TO LOCK) to prevent unauthorized use. If
not working with the machine for a long period of time
and there is the possibility that third parties, especially
children could use it, remove the safety key (REMOVE
TO LOCK) with the switch in the OFF position. Leave the
key in a safe place. Do not lose it because you will not be
able to use the planner.
• To turn ON the planner, insert the safety key (REMOVE
TO LOCK) and lift the switch in the ON position.
• To turn OFF the planner, lower the switch onto the OFF
position.
WARNING
• Double check the switch is in the
OFF position before connecting the planer into the
power supply.
Power Overload Protection
• The planer is built with an overload protection switch (I). If
overloaded, the switch will trigger. To restart the motor, follow
these steps:
1.- Set the switch (H) in the OFF position.
2.- Leave it cooling down at least 5 minutes.
3.- Press the overload protection switch (I).
4.- Set the switch (H) in the ON position to start the equipment.
NOTE: If the equipment shuts down again, please go to a
Authorized Service Center.
G
Switch
The planer cannot
run without the safety
key in place
H I
ENGLISH
9