Tabla de contenido
Idiomas disponibles
Idiomas disponibles
PRODUCT
SPECmFRCATIONS
MODEL
NUMBER
917.377282
SERIAL
NUMBER
DATE OF PURCHASE
HORSEPOWER:
&0
DISPLACEMENT:
It.6
CUo IN_
GASOLINE
CAPACITY/TYPE:
1.6QUARTS
.
UNLEADED
REGULAR
OIL TYPE
(API-SFiSG/SH):
SAE 30 (ABOVE
32°F)
SAE 5W-30
(BELOW
32°F)
OtL CAPACITY:
20 OZ&
SPARK
PL.UG(GAP:
.,030")
CHAMPION
RJ19L
VALVECLEARANCE:
INTAKE:
_005" - .007"
EXHAUST_
.007"-
.009"
SOLID
STATE IGNITION
AIR GAP:
.010 IN.
BLADE
BOLT TORQUE:
35..40 FT. LBS.
The model
and serial numbers
will be found on a decal attached
to the rear of the
lawn mower housing.Record
both serial number
and date of purchase
in space
provided
above,
LAWN
MOWER
Always
observe
safety rules when
performing
any maintenance.
TIRES
. Keep tires free of gasoline,
oil, or insect
control chemicals
which can harm
rubber.
- Avoid stumps,
stones,
deep ruts, sharp
objects
and other hazards that may
cause tire damage.
BLADE
CARE
For best results, mower
blade must be
kept sharpo
Replace
bent or damaged
blades.
TO REMOVE
BLADE
= Disconnect
spark plug wire from spark
plug and place wire where
it cannot
come in contact
with spark plug,
• Turn lawn mower on its side,
Make sure
air filter and carburetor
are up.
° Use a wood
block between
blade and
mower
housing
to prevent
btade from
turning
when
removing
blade bolt.
• Protect
your hands with gloves
and/or
wrap blade with heavy cloth°
o Remove
blade bolt by turning
counter-
clockwise,
Use a 9/16" box or opemend
wrench.
o Remove
blade and attaching
hardware
(bolt. lock washer
and hardened
washer),
NOTE:
Remove
the blade adapter
and
check the key inside
hub of blade adapter.
The key must be in good condition
to work
properly.
Replace
adapter
if damaged.
TO REPLACE
BLADE
° Position
the blade adapter
on the engine
crankshaft°
Be sure key in adapter
and
crankshaft
keyway
are aligned.
- Position
blade on the blade adapter
aligning
the two (2) holes in the blade
with the raised lugs on the adapter,
. Be sure the trailing
edge of blade
(opposite
sharp edge) is up toward the
engine_
° Install the blade bolt with the lock
washer
and hardened
washei' into blade
adapter
and crankshaft.
• Use block of wood between
blade and
lawn mower
housing
and tighten
the
1I
Tabla de contenido
