Immediately prepare your lawn mower for
storage at the end of the season or if the unit
will not be used for 30 days or mote,
LAWN
MOWER
When lawn mower is to be stored for a period
of time, clean it thoroughly, remove all dirt,
grease, leaves, etc Store in a clean, dry area
o Clean entire lawn mower (See "CLEANING"
in the Maintenance section of this manual).
,, Lubricate as shown in the Maintenance
section of this manual
o Be sure that all nuts, bolts, screws, and pins
are securely fastened. Inspect moving
parts for' damage, breakage and wear.
Replace if necessary.
o Touch up all rusted or chipped paint
surfaces; sand lightly before painting.
HANDLE
You can fold your lawn mower handle for
storage.
o Squeeze the bottom ends of the lower
handle toward each other until the lower
handle clears the handle bracket, then
move handle forward
o Loosen upper handle mounting bolts
enough to allow upper handle to be folded
back°
IMPORTANT:
When folding the handle for
storage or transportation,
be sure to fold the
handle as shown or you amy damage the
control cables.
. When setting up your handle front the
storage position,the lower handle will
automatically lock into the mowing position.
Lower
handle
Squeeze to fold
Hairpin
cotter
Handle
bracket
Operator presence control bar
Fold foward
for storage
Upper
Fold
backward
Lower
Mowing
handle
position
ENGINE
FUEL SYSTEM
IMPORTANT:
It is important to prevent gum
deposits from forming in essential fuel system
parts such as carburetor; fuel filter; fuel hose or
tank during storage. Also, experience indicates
that alcohol blended fuels ( called gasohol or
using ethanol or methanoJ) can attract
moisture which leads to separation and
formation of acids during storage Acidic gas
can damage the fuel system of an engine
while in storage,
,, Drain the fuel tank.
" Start the engine and let it run until the fuel
lines and carburetor are empty,
,, Never use engine or carburetor cleaner
products in the fuel tank or permanent
damage may occur,,
- Use fresh fuel next season.
NOTE:
Fuel stabilizer is an acceptable
alternative in minimizing the formation of fuel
gum deposits during sterage_ Add stabilizer to
gasoline in fuel tank or storage container,
Always follow the mix ratiofound on stabilizer
container; Run engine at least 10 minutes
after adding stabilizer to allow the stabilizer to
reach the carburetor. Do not drain the gas
tank and carburetor if using fuel stabilizer.
16