Cooper Lighting RFM189 Instrucciones página 2

RFM189_W 825-0149.qxd:Layout 1
Congratulations. You have just purchased a Cooper Lighting digital wireless
communication system. The battery operated motion sensor contains a radio
frequency (RF) transmitter and can be mounted within 100´ of the alarm module.
When motion is detected outside, the indoor alarm/lamp module will sound an
alarm and/or turn on any standard household lamp that is plugged into the
module. Once motion has stopped, the indoor lamp (if plugged into module)
will turn off after pre-selected time set on the sensor head.
What you need
• Phillips screwdriver
• (4) AA batteries
What's included
• Battery operated motion sensor (A)
• Motion sensor mounting screws (B)
• Indoor alarm/lamp module (C)
What to know
PLEASE READ THESE IMPORTANT SAFETY INSTRUCTIONS
• Motion sensor is cULus LISTED for wet locations and can be used indoor or
outdoor. Indoor alarm/lamp module is for indoor use only.
• The indoor alarm/lamp module must be plugged into a 120Volt, 60Hz power
source. Any other connection voids warranty.
• For proper operation and protection against damage, the motion sensor head
adjustment knobs must be facing the ground.
• Disassembly of your fixture will void the warranty.
• Exercise care in handling the batteries in order not to short the battery with
conductive materials such as rings, bracelets and keys. The battery or
conductor may overheat and cause burns.
• Observe proper polarity orientation between the batteries and
battery compartment.
• Do not mix old and new batteries or batteries of different sizes in this product.
• This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Under Part 15 of
the FCC Rules, any changes or modifications to the motion detector described
in this instruction sheet that are not expressly approved by Cooper Lighting,
LLC could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
Call for customer service and/or missing or damaged parts (800-334-6871)
6/5/08 3:26 PM Page 2
CRFM189, RFM189
CRFM189W, RFM189W
A
2
B
C