Idiomas disponibles
Idiomas disponibles
EN
e. Check if the DMXcables run near or run alongside to high voltage cables that may cause
damage or interference to Dmx interface circuit.
3. Some units don't respond to the easy controller
a. You may have a break in the DMX cabling.Check the LEDfor the response of the
master/slave mode signal.
b. Wrong DMX address in the unit .Set the proper address.
4. One of the channels is not working well
a. The stepper motor might be damaged or the cable connected to the PCB is broken.
b. The motor ' s drive IC on the PCB might be out of condition
5. Fixture Cleaning
The cleaning of intermal and external optical lenses and/or mirrors must be carried out
periodically to optimize light output.Cleaning frequency depends on t
which the fixture operates :damp,smoky or particularly dirty surrounding can cause greater
accumulation of dirt on the unit's optics.
a. Clean with soft cloth using normal glass cleaning fluid.
b. Always dry the parts carefully.
MINI BEAM 101
User Manual/Manual de uso
he en vironment in
Pag 9
