D-Link DKVM-2KU Guia De Instalacion página 3

Check Your Package Contents
Install the DKVM-2KU
To avoid mouse and keyboard errors at computer boot-up time, make sure the
power of your computers is turned OFF before you connect the KVM cables.
A.
Attach your monitor's
VGA connector to the
console port of the
DKVM-2KU.
The following steps apply to both computers that you are going to use with the DKVM-2KU:
D.Attach the DKVM-
2KU's keyboard cable
to the PS/2 keyboard
port on the back of
your computer case.
Note: To share your USB device(s), attach the USB A type connector of your USB hub or device
to the console port of the DKVM-2KU. After that, attach the USB cable in the DKVM-2KU's KVM
cable set to the USB port located on the back of your computer case.
Quick Installation Guide
DKVM-2KU
2-Port PS/2 USB KVM Switch
B.
Attach your PS/2
keyboard connector to
the DKVM-2KU
keyboard port.
E.Attach the DKVM-
2KU's mouse cable to
the PS/2 mouse port
located on the back of
your computer case.
1
Your package should contain:
- The DKVM-2KU switch
- 2 sets of KVM cables attached to
this switch
- This Quick Installation Guide
C.
Attach your PS/2
mouse connector to the
DKVM-2KU mouse
port.
F.
Attach the DKVM-
2KU's monitor cable to
the VGA port located
on the back of your
computer case.