Chin Strap - dye INVISION i4 Manual Del Proprietário

8
i4-Manual-Multi-Redux-FINAL-cs4.indd 8
ATTACHING THE CHIN
STRAP
1
To connect the strap, hold each end of the buckle and line
them up so that the forks are pointing toward the opening
of the other buckle. Insert the fork part of the buckle into
the other one until you hear a little snap noise; that noise
will indicate that your chin strap is locked. Once you have
Figure 10
Figure 10
heard that click, your chin strap is now ready for use.
[See Figure10]
2 To release the strap simply pinch the two rounded bumps
on the buckle until they are lower then the side wall of
the buckle. Once the bumps are lower, pull one end of the
strap away from the other until the buckle is completely
separated, then your strap will be released.
3 To adjust the size of the strap simply pinch the side locker
Figure 11
from end to end and rock the locker back and forth until the
strap becomes looser.
To tighten it grab one part of the strap and then slide the
locker down toward the mask. This will cause the strap to
get tighter.
CHANGING THE SOFT
EARPIECES AND GOGGLE
Figure 12
STRAP
1
The gray retention clips should be in the unlocked forward
position.
2
While keeping the lower guide tab of the gray retention clip
W W W . D Y E P A I N T B A L L . C O M
[See Figure 12]
[See Figure 11]
9/26/11 10:41 AM