Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1.3 Specification table:
CAPACITY
MODEl
(Plates/baskets)
DPC-28
40-45
DPC-34
40-45
DPN-28
40-45
DPN-34
40-45
DCN-55
5-6
2. INSTALLATION
2.1 General information:
The plate/basket dispenser should be unpacked, installed and tested by qualified service personnel.
After bringing it into the room where it is going to be installed, the device should be left for approximately 3
hours so that it reaches the ambient temperature. Then it can be connected to power supply.
THE MANUFACTURER WILL NOT BE HELD LIABLE FOR ANY PERSONAL
OR MATERIAL DAMAGE TO THE MACHINE RESULTING FROM THE
INCORRECT INSTALLATION ORIGINATED BY FAILURE TO COMPLY WITH
2.2 Transport, lifting, unpacking, storage:
Correct and safe transport:
Use equipment appropriate for the weight and structure of the devices.
Cover corners and sharp edges.
Before carrying:
Secure the area against unauthorised personnel.
Make sure that the load is properly secured.
Check all loose components lest they should fall when being lifted.
Try to lift the load as vertically as possible so as not to make any dents in it.
While carrying the load, make sure that it is as near the ground as possible.
CUTOUT
DIMENTIONS
DIMENTIONS
(mm)
(mm)
Ø407
Ø417 x 732
Ø466
Ø477 x 732
Ø375
Ø391 x 732
Ø434
Ø451 x 732
642 x 602 x
610 x 535
713
THE MANUFACTURER'S SPECIFICATIONS.
2
VOLTAGE
POWER
(V)
(W)
220-230V
480
50/60hz
480
-
-
-
-
-
ENGLISH
WEIGHT
(Kg)
20
26
10
16
19
Tabla de contenido
