Removing The Accessories; Setting The Operating Mode - Flex CHE 4-32 SDS-plus Manual De Instrucciones

 Insert the cutting accessory (1.) and
turn (2.) until it locks.
 Check lock by pulling on the cutting
accessory.

Removing the accessories

WARNING!
Before performing any work on the power
tool, pull out the mains plug.
CAUTION!
Used cutting accessories may become hot.
Wear protective gloves!
 Pull the locking sleeve backwards (1.).
 Remove the cutting accessory (2.).
Fitting the three-jaw chuck
NOTE!
To fit a three-jaw chuck you will need the
original adapter from the FLEX accessories
range.
 Screw the three-jaw chuck onto the
adapter (1.).
16
 Insert the adapter (2.) and turn (3.) until it
locks.
 Check the lock by pulling on the three-
jaw chuck.

Setting the operating mode

CAUTION!
Do not change the operating mode until
the power tool has come to a stop.
 Setting rotary knob to the required
operating mode:
Drilling
Hammer drilling
Setting the chisel position (see
below)
Chiselling
NOTE!
– The rotary knob must audibly click into
place in all positions.
– Do not switch on the power tool in the
position (setting the chisel position).
Setting the chisel position
The chisel can be turned to a position which
is ideal for the work to be performed.
 Move the operating mode rotary knob to
the symbol (1.).
 Turn the chisel until it is at the required
angle (2.).
CHE 4-32 SDS-plus