LawnMaster NPTGSS2617A Manual Del Operador página 26

MAINTENANCE
■ Press and rotate the spool head clockwise to wind the line in the spool (Fig. 27).
■ Cut off the line in the middle leaving some of the line out.
NOTE: Always clean the trimmer head cover and trimmer head housing before reassembling the
trimmer head.
NOTE: Always clean the trimmer head before replacing the spool.
■ Check the trimmer head cover, spool and trimmer head housing for wear and replace parts if
necessary.
NOTE: Only use the appropriate cutting line specified in this manual.
TRIMMER HEAD REPLACEMENT
■ Stop the engine and remove the battery pack.
■ Place the trimmer on a flat stable surface with the trimmer head facing upward.
■ Insert the provided hex wrench into the hole on the flange to lock the spindle. Then rotate the
trimmer head clockwise to remove (Fig. 28).
■ To install the new trimmer head, hold the hex wrench to lock the spindle. Then rotate the
trimmer head counter clockwise to install. Make sure the trimmer head is installed tightly.
■ Remove the hex wrench from the hole.
CLEANING THE EXHAUST PORT, MUFFLER AND SPARK ARRESTOR
NOTICE:
The spark arrestor on this product has not been evaluated by the USDA Forest Service and cannot
be used on U.S. forest lands. In addition, product users must comply with Federal, State, and local
(See Fig. 28)
26
Fig. 27
Fig. 28