Supplied Components; Preparing The Remote Control Unit; Installing The Batteries - Sharp PN-L401C Manual De Instalación

If any component should be missing, please contact your dealer.
 Liquid Crystal Display Monitor: 1
 Remote control unit: 1
 Cable clamp: 3
 Power cord: 1
 Remote control unit battery
(R-03 ("AAA" size)): 2
 CD-ROM (Utility Disk): 1
 SHARP Display Connect License: 1
 Setup Manual (this manual): 1
* SHARP Corporation holds authorship rights to the Utility Disk program. Do not reproduce it without permission.
* For environmental protection!
Do not dispose of batteries in household waste. Follow the disposal instructions for your area.

Preparing the Remote Control Unit

Installing the batteries

1. Place your finger on the part marked with the ▲, and
then pull the cover off.

Supplied Components

 Touch pen: 1
 Tray: 1
 Tray mounting screw/
camera mount screw (M3) : 2 each
 USB cable: 1
 Camera mount: 1
 Camera screw (inch thread): 1
 Logo sticker: 1
 Vertical sticker (Operation panel): 1
2. See the instructions in the compartment and put in the
batteries (R-03 ("AAA" size) x 2) with their plus (+) and
minus (-) sides oriented correctly.
3. Close the cover.
Stand
 Stand rod: 2
 Stand leg: 1
 VESA angle: 1
 Stand mounting screw (M3/M4/M6): 4 each
5
E