Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
User Manual
Depth Detection Mode LEDs
LED de modo de detección profunda
Mode de détection de profondeur DEL
LEDs de modo de detecção profunda
1
AC
STANLEY® Stud Sensor 150
The Stud Sensor 150 uses electronic signals to locate the edges of studs, joists or live AC wires
through drywall or other common building materials. Once the edge of a stud has been detected,
the Stud Sensor 150 displays red LEDs and sounds an audible tone. A marking notch allows you
to easily note the stud edges on the wall.
Note: Read all instructions prior to operating the Stud Sensor 150 and DO NOT remove any labels
from the tool.
OPERATING INSTRUCTIONS
Battery
Open door on back of unit and connect a 9 volt Alkaline battery (Type 6LR61) (not included) to
clip. Put battery back into case and close back battery door.
Note: Recommend to replace a new 9 volt battery when low battery - flashing green LED.
Usage
Detecting Wood / Metal Studs
1) Hold the Stud Sensor 150 flat against the surface, making firm contact.
2
Power LED
LED de encendido
Alimentation DEL
LED de energia
2
AC
Marking notch
Muesca de marcación
Encoche repère Encoche repère
Fenda de marcação
Edge Detection LED's
LED de detección del borde
Détection des contours DEL
Edge Detection LED's LEDs de
detecção de borda
AC
Live wire warning LED
LED de advertencia de cable vivo
Témoin à DEL de fil sous tension
LED de aviso de fio sob tensão
Activation Button
Botón de activación
Bouton d'activation
Botão de Ativação
3
AC
4
AC
Tabla de contenido
