Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALLATION : DOSAMAX BOTTLE FILL
1.) Reconnect discharge tube to
discharge port
4.) Place and hang bottle fill
bracket underneath spout
INSTALLATION AND OPERATION
1.) Insert pick-up tubing into
chemical container. 1.2 meter (47")
suction tube supplied
4.) Use supplied hex wrench and
turn clockwise in hole to lock-in
dosing amount. If you need to
change dosing amount, use Allen
wrench and turn counter clockwise
in hole to unlock dial
Page 4 of 16
2.) Align cover, making sure the
green ready indicator is aligned
with opening and chemical suction
tube is aligned with tab opening.
5.) Drill and screw three screws in
shown areas to hang the bracket
2.) Turn dial to 50 ml position and
push dial. Repeat pushing action
until DosaMAX Jr. is primed.
5.) Fully push dial in to dose set
dosing amount
3.) Screw at the bottom and top of
cover to reattach cover.
6.) Adjust bottle fill tray to
preferred height
50 ml
3.) Turn dial to your preferred
dosing amount.
(Warning: Do not
turn over 50 ml)
6.) Dial should not be pushed
again until green indicator is fully
present
S100322 Rev: (REL)
Tabla de contenido
