Idiomas disponibles
Idiomas disponibles
Introduction
This product is a wireless air mouse and keyboard. You can use it to
control what happens on the television screen. It comes with a receiver
that can be connected into either USB 1.1 or USB 2.0 ports. It has four
levels of sensitiviy, from 600 to 1200. It is power efficient. After being
inactive, for one minute, it enters sleep mode and uses a current of less
than 20uA. This greatly improves battery life. The keyboard has a low
voltage indication function, which lights up when the battery voltage is
less than 3.4V. This product uses a 2.4G wireless transmission system.
The transmission distance is up to 10 meters.
Key functions
Mouse on / off. The mouse function can be set to a variety of modes.
Mode 1: Hold the button with the Android logo down until the mouse is
activated Keep the button pressed down. If you point the remote around
the screen, the cursor will follow it. When you stop pressing the button,
the mouse will be deactivated.
Mode 2: Press the button with the Android logo on it down once and it
will enter mouse mode. You can now freely move around the screen un-
til you decide not to continue. Press the button once more to deactivate
the mouse function.
Mode 3: Double click the button with the Android logo on it to simulate
holding the left mouse button down. Once you have finished scrolling
or doing what you needed to do, then you can double click again to
deactivate the option.
Function Instructions
a) Pairing: The Flypad II synchronizes to your device automatically,
when its conected. Otherwise, press the [ ESC ] and [ G] keys together
for approximately 4 seconds. The left LED lights will blink rapidly. If the
left LED light flashes slowly three times and remains on, it means that
the remote pairing was succesful.
b) Mouse sensitivity adjustment: Press [ Ctrl ] and [ ESC ] together. The
left LED light will flash various times, according to the newly selected
sensitivity level. For example, if it has been adjusted 3 levels, it will flash
3 times. There are up to 4 levels of sensitivity to choose from.
c) Switch between the vertical and horizontal axis sensors of the
remote: Press [ Ctrl ] and [ BackSpace ] together. The left LED will flash
once to indicate succesful change between axis.
d) Low voltage: When the battery voltage is lower than 3.4V, the right
LED lights flash. This means that the battery will need to be replaced
soon.
4
english
