Strainer Installation - Transform QL642 Manual Del Usuario

Installation (continued)

STRAINER INSTALLATION

- Apply plumbing putty or silicone sealant to the top side of
the drain opening .
- Insert the strainer body (8) into the drain opening and press
it down until it is evenly seated .
- Assemble the rubber gasket (9), fiber washer (10)
and strainer locknut (11) onto the strainer body from
underneath the sink . Hand tighten the strainer locknut until
it is snug . Do not overtighten .
- Insert the plastic flange (12) into the flange-end of the
tailpipe (13) (not supplied) then secure the tailpipe to the
strainer body using the connecting nut (14) . Tighten the
connecting nut until it is snug . Do not overtighten .
- Remove excess sealant from around the drain opening .
NOTE:
The tail pipe is not supplied.
QL642
Sink
8
Strainer Basket (15)
Strainer Body (8)
Sealant
Rubber Gasket (9)
Fiber Washer (10)
Strainer Locknut (11)
Plastic Flange (12)
Tailpipe (13)
Connecting Nut (14)