IOGear HVER PRO X Guia De Inicio Rapido página 4

LED Backlight Functions
The HVER PRO X has 8 built-in backlight modes with 47 different color/pattern
combinations, plus 3 DYI per-key user programmable lighting modes. The
backlighting can be further customized issuing the downloadable HVER PRO X
user software. Press Fn + PrtSc to cycle through the 8 different color modes:
Sparkle, Monochrome, Fixed Single-Color, Breathing, Follow, Rainbow Ripple,
Explode and Wave.
Backlight Color Adjustments
Press Fn + Home or Fn + End to cycle up or down through the 9 color options
available within each backlighting mode: Rainbow, White, Purple, Blue, Cyan,
Green, Yellow, Orange and Red. Note: Sparkle and Monochrome backlight
modes do not have color options available.
Backlight Pattern Adjustments
Press Fn + PgUp to increase brightness
Press Fn + PgDn to decrease brightness
Press Fn + ◄ to shift light flow direction left
Press Fn + ► to shift light flow direction right
Press Fn + + to increase light speed
Press Fn + - to decrease light speed
DIY Custom Lighting
The HVER PRO X has three DIY lighting modes that can be programmed
without using the HVER PRO X user software.
To set the DIY lighting mode:
1. Press Fn + F9, Fn + F10 or Fn + F11 to select a DIY backlighting mode.
2. Press Fn + Pause to start DIY programming. The 4 status LEDs will begin
flashing.
3. Press the keys you want to light. Each press will cycle the key color as
follows: Off, Red, Green, Blue, Yellow, Purple, Cyan, White.
4. Press Fn + Pause to exit and save the setting. The 4 status LEDS will stop
flashing.
Note: Change the FN key color last. When changing the Fn key color, cycle to
the color you want but do not release the key. Continue holding down the key
and press Pause to save, then you can release the key.
3