Tabla de contenido
Idiomas disponibles
Idiomas disponibles
TRANSAXLE
GEAR SHIFT LEVER NEU=
TRAL ADJUSTMENT
The transaxle
should
be in neutral
when
the gear shift lever is in neutral
(N) (lock
gate)
position.
The adjustment
is preset
at the factory;
however,
if adjustment
is
needed,
proceed
as follows:
1.
Make sure transaxle
is in neutral
(N).
NOTE:
When
the tractor
rear wheels
move freely,
the transaxle
is in neutral.
2.
Loosen
adjustment
bolt in front of the
right rear wheel.
3.
Position
the gear shift lever
in the neu-
tral (N) position.
4.
Tighten
adjustment
bolt securely.
NOTE:
If additional
clearance
is needed
to get to adjustment
bolt, move mower
deck height
to the lowest
position.
Gearshift Lever
Neutral
Lock
Adjustment
Bolt
Gate
TO REMOVE WHEEL FOR REPAIRS
1.
Block up axle securely.
2.
Remove
axle
cover,
retaining
ring and
washers
to allow
wheel
removal
(rear
wheels
have a square
key - Do not lose).
3.
Repair
tire and reassemble.
NOTE:
On rear wheels
only:
align
grooves
in rear wheel
hub and axle.
Insert
square
key.
4.
Replace
washers
and snap
retaining
ring securely
in axle groove.
5.
Replace
axle cover.
NOTE:
To seal tire punctures
and prevent
flat tires due to slow leaks,
purchase
and
use tire sealant
from
Sears.
Tire sealant
also prevents
tire dry rot and corrosion.
Washers
Retaining
Ring
FRONT WHEEL TOE=IN/CAMBER
Your new tractor front wheel toe-in and
camber is set at the factory and is normal.
The front wheel toe-in and camber are not
adjustable.
If damage has occurred to
affect the factory set front wheel toe-in or
camber, contact a Sears or other qualified
service center.
TO START ENGINE WITH A WEAK
BAT=
TERY
AI_,WARNING:
Lead-acid batteries gener-
ate explosive gases.
Keep sparks, flame
and smoking materials away from batter-
ies. Always wear eye protection when
around batteries.
If your battery is too weak to start the en-
gine, it should be recharged.
(See "BAT-
TERY" in the MAINTENANCE
section of
this manual).
If "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT:
Your tractor is equipped
with a 12 volt system. The other vehicle
must also be a 12 volt system. Do not use
your tractor battery to start other vehicles.
TO ATTACH
JUMPER
CABLES
-
1.
Connect
one end of the RED cable
to the POSITIVE
(+) terminal
of each
battery(A-B),
taking
care not to short
against
tractor
chassis.
2.
Connect
one end of the BLACK
cable
to the NEGATIVE
(-) terminal
(C) of
fully charged
battery.
3.
Connect
the other end of the BLACK
cable
(D) to good chassis
ground,
away from fuel tank and battery.
TO REMOVE
CABLES,
REVERSE
ORDER
-
1.
BLACK
cable
first from chassis
and
then from the fully charged
battery.
2.
RED cable
last from
both batteries.
Weak or Dead
Fully Charged
Battery
Battery
Axle Cover
I
--,Square Key (Rear
Wheel Only)
24
Tabla de contenido
