Section 2 - Operating Instructions; Setup - Drive Medquip MQ5800 Manual De Instrucciones

DO NOT pull on the power cord to unplug the unit from an electrical
outlet.
DO NOT overload wall outlets.
Pump maintenance MUST be performed by a qualified service tech-
nician.
SAVE THESE INSTRUCTIONS
SECTION 2 –
OPERATING INSTRUCTIONS
Remove the compressor from the carrying case before use.
Do not operate unit without filter.
Avoid operating this product in a dusty environment.
Otherwise, premature compressor wear could occur.
NOTE: Clean and disinfect the nebulizer and mouthpiece before us-
ing the device for the first time. Refer to Cleaning and Disinfecting.

Setup

NOTE: For this procedure, refer to FIGURE 2.1
1. Place the unit on a table or other flat, stable surface. Be sure
you can easily reach the controls when you are seated.
Make sure the power switch is in the off "O" position.
2. Remove the nebulizer kit from the carrying case.
3. Gently twist the nebulizer to separate it into two sections.
4. Be sure the pick-up funnel is in place in the bottom section of
the nebulizer cup.
8 English
WARNING
!
CAUTION