Step 2 - Attach Pole To Support Brackets; Step 3 - Load Cylinder Housing Onto Pole; Step 4 - Attach Reflector Studs To Screen Cover; Step 5 - Attach Head Assembly To Pole - Jiangsu Gardensun Furnace HSS-A-SS El Manual Del Propietario

Step 2 – Attach Pole to Support Brackets
Put the upper pole onto the lower pole, using 2pcs
3/16" screws to firmly secure 2pcs pole.The warning
label on the upper pole should be on the same side as
the flat plate of the lower pole.
Install Pole onto three Support Brackets.
Attach Pole to Support Brackets using six large bolts
& six flange nuts.
6 Req'd Large Bolts
Fully tighten all of the screws.
6 Req'd Small Flange Nut
.
.
Step 3 – Load Cylinder Housing onto Pole
Load Cylinder Housing onto Pole.
Slide Cylinder Housing down.
.
.
Step 4 – Attach Reflector Studs to Screen Cover
Insert 3 Reflector Studs & 3 Flat Washers.
Tighten studs securely.
3 Req'd Reflector Studs
.
Step 5 – Attach Head Assembly to Pole
Screw off 4 small bolts.
4 Req'd Small Bolts
Head Assembly
3 Req'd Large Flat Washers
5