Wtx500 - Eden WTX Serie Manual Del Usuario

The WTX500 provides the ability to easily take Eden tone and power with you in a compact portable package. Not only can you get great
tone and power out of this punchy little amplifier, but you also have access to an effects loop, auxiliary inputs and a flexible DI on the rear
of the amplifier. With its 500W power output the WTX500 can deliver a surprising amount of volume.
WTX500 Front Panel Navigation:
1. Illuminated Eden logo; Illuminates when unit is switched on.
2. Input; connect your instrument to the amplifier.
3. Tuner Mute Indicator; illuminates when tuner mute is active.
4. Gain Control/Input Pad; Adjust the amount of input signal to
the amplifier here/Pull this control to engage a -12bB pad for
higher output instruments.
5. Tuner Mute Switch; Press to toggle tuner mute on/off.
6. Level Indicator; Use this to help set your input signal level this
should illuminate on your loudest/lowest notes.
7. Enhance Control; Providing Eden tone shaping use this control
to increase the amount of proprietary EQ sweep in your sound /
pull this control to bypass the amplifiers internal compressor.
8. Effects Loop Send; Signal Out.
9. Bass Level Control; Use this control to select the amount of
cut or boost you require in the low frequency range / Pull control
to engage Bass Boost function to achieved added low end.
10. Effects Loop Send; Signal In.
11. Mid Level Control; Use this control to select the amount of
cut or boost you require in the mid frequency range / pull
control to move where in the mid frequency range mid cut or
boost is applied.
12. Auxiliary Input Left.
13. Treble Level Control; use this control to select the amount of
cut or boost you require in the Higher frequency / Pull this
control to move the DI signal to post position in the amplifier.
14. Auxiliary Input Right.
15. Limit Indicator; Displays when amplifier power output is
being reached.
E D E N | M E T R O M I X S E R I E S | W T X 5 0 0 - 7
WTX500 Quick Start Guide
16. Master Control; Adjust the overall output level of the unit.
17. Tuner Out; Connect your rack or foot pedal tuner.
WTX500 Rear Panel Navigation:
1. Power Inlet; Insert supplied power cord.
2. Power Switch; Turn your amplifier off and on.
3. Footswitch; Connect optional footswitch here to toggle tuner
mute and enhance functions.
4. Recording DI Out; Take your DI line for a recording console or
desk from.
5. Ground Lift Switch; Switch ground lift feature for the XLR
Recording DI output.
6. DI Level Control; Adjust the output level of the DI.
7. Headphone Out; Connect your headphones to the amplifier.
8. ¼ Jack Output 1; Connect your amplifier to a speaker cabinet.
9. Speakon Output 1; Connect your amplifier to a speaker cabinet.
Always ensure that that the total load for your amplifier does not fall
below the recommended 4 ohm impedance for this amplifier as it can
cause the protection circuit to engage and in some cases may damage
the amplifier.
N E V E R C O M P R O M I S E | 9
T M