Tabla de contenido
Idiomas disponibles
Idiomas disponibles
WARNING Risk of Electrical Shock and Fire.
The heater must be properly installed before it is
used.
1. Do not operate without grill.
2. Keep electrical cords, drapery, furnishings and
other combustibles at least 3 feet away from the
front of the heater and 6 inches away from the
sides.
3. Do not tamper with the over temperature limit
control.
4. If the heater over temperature limits trip more
than once per day, the heater must be replaced.
Digital Display
Fan Mode
Indicator
Temperature
Heating
Mode
Indicator
Heater Modes
Using the rocker switch, you can move the switch to three
modes.
HEAT
Rocker Switch
CENTER POSITION: NO HEAT MODE
After a brief cool down period (up to 4 minutes), the heater will
shut down. It will not resume heating until the rocker switch is
flipped to the HEATING (left) position.
fan is animated
No Heat, Cool Down
LEFT POSITION: HEAT MODE
Your ComPak Energy Plus heater has a unique variable speed
blower that auto adjusts the heat output based on the room's
requirements. Once you set the thermostat to your desired tem-
perature, the heater will vary the wattage output for maximum
efficiency.
The digital display will show the level of heat being output to
maintain the room's temperature.
Heating Full Power Heating Mid Power
RIGHT POSITION: FAN ONLY MODE
The FAN ONLY mode can circulate air but will not supply heat.
Three fan speeds are available. To adjust the fan speed: With
rocker switch in the RIGHT position, push top (+) or bottom (-)
digital buttons up or down. Display will read "1" for low speed,
"2" for medium speed, or "3" for high speed during the set up
process, then resume to temperature display.
Fan Only / No Heat
Page 6
OPERATING INSTRUCTIONS
Fan Operation
Fahrenheit Setting
Night/Away Mode
Icon
Proportional Heat
Control Indicator
NO FAN
NO HEAT
FAN
ONLY
No Heat
Heating Low Power
5. Clean heater at least every six months.
6. After allowing the heater to cool, turn power off
at circuit breaker panel before removing grill.
7. Use a hair dryer or vacuum on blow cycle to
blow debris through the top element (do not touch
element).
8. Install the grill before turning on power.
WARNING: Any other service not detailed in
this Owner's Guide should be performed by an
authorized service representative.
Up Button
Digital Display
Down Button
Night Button
Rocker Switch
Setting Desired Heating Temperature
• Turn rocker switch to HEAT mode.
• Touch the up
button or the down
to set your desired temperature.
Temperature Setpoint Range: 40˚F - 90˚F
Programming Your Night/Away Button
You can preset a night or away temperature
set point, for quick and easy "one-touch"
energy savings.
• Turn rocker switch to HEAT mode.
• Push Night
button to activate. The moon
icon will show in display screen. The "night/
away" setpoint temperature will flash for 5
seconds.
• Push the Up
or Down
change your desired night/away set point.
• To return to your previous HEAT set point
when you awake or return, push the Night
again. The setpoint temperature will flash
for 5 seconds. The moon icon will no longer
be in display screen.
• To return to your previous night/away set-
point, simply push the Night
Max/Min Temperature Lock
You can preset a maximum and/or minimum set point as a child
safety or tamper proof option. To preset a maximum setpoint:
• Move rocker switch to NO HEAT mode.
• Press and hold both the Night
at the same time, for at least 5 seconds, until the "HL" (high
limit) is displayed.
• Release buttons: temperature setpoint will flash and alternate
with "HL" on the display.
• Using the Up
or Down
sired set point.
• Turn rocker switch back to HEAT mode.
• To remove the lock, follow same instructions, and set to maxi-
mum of 90 degrees.
• To preset a minimum set point, follow same steps, but press
and hold both the Night
(low limit) is displayed.
Energy Saving Tips
• Set your Night/Away
set point to as low as you are com-
fortable, for a cooler nighttime temperature.
• When you exit the room or leave your home, push the Night
button to drop the temperature set point.
• If your heater is positioned in a drafty area or exposed to
direct sunlight, temperature reading will be affected. Set tem-
perature to desired comfort level, not a "number" on the digital
display.
• If you will be away for an extended period of time (and have
no concerns about freezing conditions), turn the rocker switch
to NO HEAT for even greater energy savings.
Control Buttons
+
NO
F
NO
HEAT
A A
NO FAN
NIGHT /
NO HEAT
NO FAN
AWAY
SLEEP
NO HEAT
FAN
HEAT
FAN
HEAT
ONLY
ONLY
Up
button
Down
NIGHT /
AWAY
Night/Away
Button
button to
Night/Away Mode
button.
button and the Up
button, set your maximum de-
and Down
buttons until the "LL"
button
Tabla de contenido
