Federal Signal 27XST Instrucciones De Instalación Y Servicio página 3

Ocultar thumbs Ver también para 27XST:
Idiomas disponibles

Idiomas disponibles

INSTALLATION AND SERVICE INSTRUCTIONS FOR FEDERAL MODEL 27XST
SAFETY MESSAGE TO INSTALLERS, USERS AND MAINTENANCE PERSONNEL
It is important to follow all instructions shipped with this product. This device is
to be installed by a trained electrician who is thoroughly familiar with the National
Electrical Code and/or Canadian Electrical Code and will follow the NEC and/or CEC
Guidelines as well as local codes.
This device should be considered a part of the warning system and not the entire
warning system.
The selection of the mounting location for the device, its controls and the routing
of the wiring are to be accomplished under the direction of the facilities engineer and
the safety engineer. In addition, listed below are some other important safety instruc-
tions and precautions you should follow:
Read and understand all instructions before installing or operating this
equipment.
Never alter the unit in any manner. Safety may be compromised if ad-
ditional openings or other alterations are made to the unit.
Do not connect this light to the system when power is on.
After installation, ensure that the setscrew and threaded joints are prop-
erly tightened.
After installation, test the light system to ensure that it operating prop-
erly
Keep unit tightly closed when in operation.
After testing is complete; provide a copy of this instruction sheet to all
operating personnel.
Establish a procedure to routinely check the light installation for integ-
rity and proper operation.
Never alter the unit in any manner. Safety may be compromised if ad-
ditional openings or other alterations are made to the unit.
Keep unit tightly closed when in operation.
Failure to follow all safety precautions and instructions may result in property
damage, serious injury, or death to you or others.
I.
GENERAL.
The Model 27XST strobe light is a visual signaling device for hazardous locations
and provides about 75−80 high-intensity flashes per minute. The effective candlepower
(ECP) of the light is 850 candelas (clear dome). The unit is UL and CSA listed for
indoor and outdoor use and has been found to comply with Type 4X (watertight and
corrosion resistant) enclosure requirements and Marine Visual Signal Device, Outside
Type (saltwater).
FOR USE IN HAZARDOUS LOCATIONS
-1-
loading