Haier DW12-PFE8 Serie Manual De Instrucciones página 23

End of washing programme
Six beeps will indicate that the wash cycle has finished, the programme indicator
light and time- remaining indicator will display "0".
Switching the dishwasher OFF
Several minutes after the programme has ended:
Set On-Off button to Off
Open the door .
Remove dishes, etc. when they have cooled down.
Turn the water tap off.
Notice:
When the appliance is already underway press the Reset
button for 3 seconds, all of the settings will be cancelled.
Interrupting the programme
Open the door.
Caution!
There is a risk of water squirting out from inside the appliance. Do
not open the door fully until spray arm has stopped rotating.
When you open the door, the dishwasher will beep ten times every thirty seconds
and the time-remaining indicator display "E1".
If the appliance has already heated up or the hot water was switched ON and
then the appliance door opened, leave the door ajar for several minutes and then
close. Otherwise, the appliance door may open due to expansion.
Close the door. After 30 seconds the programme will start from the point it was
interrupted.
Notice:
Interrupt or cancel a programme in progress ONLY when
absolutely necessary.
Cancelling or modifying a cycle while underway
A cycle that is underway can be modified if it has only been running for a short
time. Otherwise, the detergent may have already been used, and the appliance
may have already drained the wash water. If this is the case, the detergent dispenser
must be refilled ( see the paragraph entitled, " Loading the detergent ").
To modify a cycle that is already underway, follow the instructions contained in
the paragraph entitled "Reset drain function", and select the programme you wish
(see the paragraph entitled, "Switching the dishwasher ON").
EN
22