Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Install the Following Luminaires
Pin
1
Insert pin of new luminaire to hinge.
3
Support fixture by hand while
rotating luminaire upwards till joint is
flat and clips are engaged.
Troubleshooting
Symptom
Luminaire will not turn on
Luminaire on through wiring will
not turn on
Luminaires to luminaire mating
in continuous run is loose
Suspension method won't
engage with luminaire
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This Class [A] RFLD
complies with the Canadian standard ICES-005 Ce DEFR de la classe [ A ] est conforme à la NMB-005 du Canada.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
2A
2
A) Join 4-pin connectors and 2-pin connectors, then push connectors back into
enclosure. B) Additional 3-pin connector for branch circuit.
Maximum distance between
suspension points shall not exceed
length of the luminaire.
4
Ensure mounting bracket is properly
engaged on both sides of groove.
Solution
• Check that the color of the supply side wires match the color of the wires they are connected to.
• Check that the LED driver connector is fully engaged to the LED light engine connector.
• Check that the through wiring connector form the previous fixture in the linear row is fully
engaged to the malfunctioning luminaire.
• Ensure that both upper and lower connecting features are correctly engaged.
• Check that the suspension method is one of the approved types in the
installation instruction.
www.gecurrent.com
GE and the GE Monogram are trademarks of the General Electric Company. All other trademarks are the property of
their respective owners. Information provided is subject to change without notice. All values are design or typical
values when measured under laboratory conditions. GE Current a Daintree Company is a business of the General
Electric Company. ©2020 GE.
IND183-Eng (Rev 01/29/20) GE2028-1139
2B
5
Terminate row with end cap of
starter kit.
Tabla de contenido
