Tabla de contenido
®
R&S
TS-PMB
6 Commissioning
To install the plug-in module, proceed as follows:
●
Run down and power off the TSVP
●
Remove the front panel from the rear side of the TSVP chassis by slackening off
the screws
Damaged backplane due to bent pins
Bent pins may result in permanent damage to the backplane.
Check the backplane connector for bent pins!
Any pins that are bent must be straightened!
When module is connected, it must be guided with both hands and carefully pressed
into the backplane connector.
●
Insert the plug-in module using moderate pressure.
●
The top snap pin on the module must locate in the right-hand and the bottom pin in
the left-hand hole on the TSVP chassis.
●
The plug-in module is correctly located when a distinct 'stop' can be felt
●
Tighten the top and bottom screws on the front panel of the plug-in module
(starting with CompactTSVP TS-PCA3 with backplane version V4.x)
Matrix modules B R&S TS-PMB with change status V2.x (recognisable from the lack of
connector X1) require a hardware change to TAZ 2.14 and a Rear IO Module TS-PRIO
plugged in to operated in the CompactTSVP TS-PCA3 with backplane version V4.x
(starting with serial number 100109). The 5-V power supply and CAN bus are supplied
via the TS-PRIO.
User Manual 1153.5233.12 ─ 05
Commissioning
11
Tabla de contenido
