Edwards GCI Manual De Instalación página 3

Figure 4: Remote key switch wiring
RKEY
Note: Remove the jumper installed on EXTSW only if you are
installing a remote key switch.
Figure 5: Switch and LED wiring
LED+
LED+
SW-
SW-
Switch and LED terminals are listed in Table 4 and Table 5.
Table 4: Switch terminal definitions
Terminal Description
J7-1 ACK/Silence SW
J7-2 Reset SW
J7-3 Signal Silence SW
J7-4 Drill SW
J7-5 Lamp Test SW
J7-6 to J7-8 Not used
P/N 3100973-ML • REV 2.0 • ISS 16MAR11
SWxx
SW–
LED+
+
LEDxx
Terminal Description
J7-9 to J7-12 SW 1 to SW 4
J8-1 to J8-12 SW 5 to SW 16
Table 5: LED terminal definitions
Terminal Description
J1-1 Reset LED
J1-2 Signal Silence LED
J1-3 Drill LED
J1-4 Ground Fault LED
J1-5 Trouble LED
J1-6 Controls Enable LED
J1-7 ACK/Silence LED
J1-8 Lamp Test LED
J2-1 Power LED
J2-2 Fire Alarm LED
J2-3 Supervisory LED
J2-4 to J2-8 Not used
J3-1 to J3-8 LED 1 to LED 8
J4-1 to J4-8 LED 9 to LED 16
J5-1 to J5-8 LED 17 to LED 24
J6-1 to J6-8 LED 25 to LED 32
Specifications
Voltage 24 VDC
Current
Standby 36 mA at 24 VDC
Alarm 146 mA at 24 VDC
Switch inputs
Quantity 5 dedicated, 21 total
Type Dry contact
Open collector outputs For LED driver use only
Current 10 mA at 5.7 V input max.
Power factor PF 1.0 (resistive)
Quantity 43
Type Common (11), zone or programmable (32)
LED current 7 mA at 5.7 VDC per LED, typical
Power wiring 14 to 18 AWG (1.0 to 2.5 mm²)
Annunciator circuit
Class/Style Class B, Redundant Class B, or Class A
Wire size 18 to 14 AWG (1.0 to 2.5 mm²)
Type Twisted pair, 6 twists per ft. min.
Length 4,000 ft. (1,219 m), max.
Baud rate 9600 to 115200 baud
Remote key switch 5 VDC at 1 mA, power-limited, unsupervised
Dimensions 3.25 × 10.25 × 1.50in. (8.3 × 2.6 × 3.8 cm)
Ground fault 0 Ω
impedance
Operating environment
Temperature 32 to 120°F (0 to 49°C)
Relative humidity 0 to 93% noncondensing
3 / 14