NuTone QTXN Serie Manual Del Usuario página 3

CONNECT WIRING
WHITE TO WHITE
BLACK
TO YELLOW
WHITE TO WHITE
BLACK
TO BLUE
RED TO RED
5. Connect electrical wiring.
Run 120 VAC house wiring to installation location. Use
proper UL approved connectors to secure house wiring to
wiring plate. Connect wires as shown in wiring
diagram(s).
INSTALL GRILLE & BULBS
6. Finish ceiling.
Install ceiling material. Cut out around housing.
7. Remove
light lens
from grille.
Insert a small flat-
bladed screw-
driver into the slot
at one end of the
light lens.
Carefully pry the
lens out.
®
RED TO BLACK
TOP / BACK
OF HOUSING
GROUNDS TO
WIRING PLATE
WIRING PLATE
120 VAC
LINES IN
(3-WIRE
PLUS GROUND
POWER CABLES)
MODELS QTXN100HL • QTXN110HL
INSTALL GRILLE & BULBS
8. Plug-in light.
Hold grille
assembly up
near housing.
Connect light
plug from grille
assembly to
receptacle inside
of housing.
9. Attach
grille.
Remove the (2)
grille mounting
screws from the
sides of the
housing. Use
these screws to
attach the grille
to the housing
as shown.
To avoid
damage to the grille: DO NOT OVERTIGHTEN SCREWS.
Tighten screws only until grille is snug against ceiling
material.
10. Install
bulbs.
The unit
accepts (2) 60-
Watt (maxi-
mum) incan-
descent bulbs
and (1) 7-Watt
night light bulb.
11. Attach
light lens.
Hook the tabs
on one end of
the lens into the
slot in the grille.
Lift other end of
lens up and
snap into place.
Page 3