Speaker Break-In - Denon Professional DN-205W Guia Del Usuario

Speaker Break-In

Speakers require a break-in period before they can be safely operated at maximum volume levels. Proper
break-in ensures that the moving parts of the speaker (the cone and cone suspension) are allowed to flex
and soften, loosening the initial stiffness and allowing the speaker to move through its full intended range.
After the break-in period, the speakers will produce richer sounding lows, warmer and smoother sounding
mids, and cleaner highs.
The best way to break-in speakers is to play normal music at moderate volume levels. The amount of time
required for speaker break-in varies based on the operating environment, but is typically between 50-80
hours. It will take somewhat longer in a cold or dry environment and a little less time in a warm or humid
environment.
Note: The break-in period does not have to be continuous.
Speaker Wire Preparation
Before attempting to make any connections it is best to consider the location, get all of the necessary
materials together, and then make all of the connections at once.
First, look at the back of your amplifier or receiver to determine what options it offers for making
connections. Amplifiers and receivers typically employ either 5-way binding posts, spring-loaded terminals,
or push terminals for the speaker connections.
A 5-way binding post can accept bare speaker wire, spade plugs, pin plugs, and banana plugs, while spring
loaded terminals and push terminals can accept either bare speaker wire or pin plugs. Refer to the
documentation that came with your amplifier or receiver to determine the maximum size/gauge speaker wire
the speaker terminals can accept.
DN-205W features push terminals, which can accept pin plugs or bare wire up to 14 AWG. If your amplifier
can accept it, you should use 14 AWG speaker wire. Using pin plugs is highly recommended as it is easier
to connect, no risk of stray wire strands shorting the connections, allows for use of heavier gauge speaker
wire in most cases, and is much easier to identify the polarity from a color coded ring on a plug then from a
subtle marking along the length of a wire.
Because the speaker wires will be run through your walls/ceiling, you must use in-wall rated wire which is
required by fire safety codes. This ensures that the wire jacket will not act as an accelerant in the event of a
fire.
Rather than using fixed length speaker wires, it is best to get a roll and cut the wires to the length you will
need them. This ensures that there is a minimum amount of excess wire. However, even if your amplifier is
off-center, the lengths of wire used for each speaker pair should be identical. This keeps the impedance on
each channel the same, which ensures that the volume levels, frequency ranges, and tonalities are identical.
Any excess wire should be snaked back and forth, not coiled, to avoid creating an inductor/antenna for
stray radio signals.
Before making the actual connections, cut each length of wire to size. Note the markings on the wire that
differentiate between each conductor. Sometimes the marking clearly identifies a positive and negative side.
Some common clearly positive and negative markings or identifiers are:
Positive Negative
Red Black
Copper Silver
+ + +
- - -
In many cases, the mark is a single stripe on the jacket of one
of the connectors. In this case the side with the stripe is
generally considered the positive side, but it really does not
matter as long as you are consistent and always use the stripe
as positive or always use it as negative.
1/4" (6 mm)
When you are ready to prepare your speaker wires, first
separate about 4" (101 mm) of wire, then strip about 1/4" (6
mm) insulation from the end and twist it to prevent stray
strands. If you plan to use banana or pin plugs (highly
4" (101 mm)
recommended), install the plugs on the wire.
3