Hammerbacher XMST-Serie Manual De Instrucciones página 49

Please observe the safety notes!
Abb_10/2015_009
Reset obligations prior to initial operation:
- The table must be in the correct position before initial operation.
- The power must be connected before initial operation.
- A reference drive must be carried out on the table before initial operation.
For this proceed as follows:
Press the 'down' button on the controls and hold it down. After
5 – 10 seconds the table will move to the lowest position and a small 'click' can be heard.
If the button is released before the process is complete then the RESET process is interrupted and must
be started again.
If it was not possible to carry out the RESET process successfully then hold the 'up' and 'down'
buttons simultaneously and hold them for at least 5 seconds. Then carry out the RESET process
again as described above.
After longer operation of the table it is possible for slight lift differences to occur between the
columns (the table is slightly 'tilted'). This difference in height is resolved by carrying out a RESET
drive.
Please retain these instructions!
49
XMST