Mowing Tips; Blade Sharpening - WOR(I)D WG744E Manual Original

At least one battery is not fully
No light is
installed or battery may be
illuminated.
defective.
At least one battery is over
discharged (please refer to
Only one light is
the battery charge condition),
flashing twice per
please recharge the two bat-
cycle.
teries at once before use again
or storage.
Only one light At least one battery is hot,
is flashing three wait for them cool down
times per cycle. before start again.
Only one light is The machine is over load.
flashing four times Raise the cutting height or
per cycle. push slowly.

MOWING TIPS

NOTE: ALWAYS INSPECT AREA WHERE
MOWER IS TO BE USED AND REMOVE ALL
STONES, STICKS, WIRE, METAL AND OTHER
DEBRIS WHICH MIGHT BE THROWN BY THE
ROTATING BLADE.
1. Mow across the face of slopes, never up-and-
down. Exercise extreme caution when changing
direction on slopes. Do not mow excessively steep
slopes. Always maintain good footing.
2. Release switch lever to turn mower "OFF" when
crossing any graveled area (stones can be thrown by
the blade).
3. Set mower at highest cutting height when
mowing in rough ground or in tall weeds. Removing
too much grass at one time can cause circuit breaker
to trip, which stops mower.
4. If a grass bag is used during the fast growing
season, the grass may tend to clog up at the
discharge opening. Release switch lever to turn
mower "OFF" and remove the safety key. Remove
the grass bag and shake the grass down to the back
end of the bag. Also clean out any grass or debris
which may be packed around the discharge opening.
Replace the grass collection bag.
5. If mower should start to vibrate abnormally,
release switch lever to turn mower "OFF" and
remove safety key. Check immediately for cause.
Vibration is a warning of trouble. Do not operate
mower until a service check has been made.
6. ALWAYS RELEASE SWITCH LEVER TO TURN
MOWER "OFF" AND REMOVE SAFETY KEY
WHEN LEAVING IT UNATTENDED EVEN FOR A
SHORT PERIOD OF TIME.
Cordless Lawn Mower
CUTTING AREA
The cutting area can be affected by several factors,
such as cutting height, lawn humidity, grass length
and density. Besides, starting and stopping the
mower too many times during operation will reduce
the cutting area.
The table below gives the relationship between
cutting conditions and cutting area.
Cutting conditions
Grass Cutting
conditions height
Very thin, cut 7cm
dry grass to 5cm
Thin, dry cut 7cm
grass to 3cm
* Used with two fully charged battery packs.
TIPS:
1) It is recommended to mow your lawn more
frequently, walk at normal pace, and not
to start/stop the mower too often during
operation. Please always use the same two
batteries and charge the two batteries at same
time.
2) For best performance, please ensure use a fully
charged battery pack and always cut off 1/3 or
less of the grass height.
3) Walk slowly when cutting long grass, so as
to have more effective cutting and properly
discharge the clippings.
4) Avoid cutting wet grass, otherwise it will stick
to the underside of the deck and the clippings
cannot be collected or discharged properly.
5) A higher cutting height shall be applied to new
or thick grass and it will extend the battery
duration
MAINTENANCE
WARNING: Stop the mower and remove the
safety key before removing the grass bag.
Note: To ensure long and reliable service, perform
the following maintenance procedures regularly.
Check for obvious defects such as a loose, dislodged
or a damaged blade, loose fittings, and worn or
damaged components. Check that the covers and
guards are all undamaged and are correctly attached
to mower. Carry out any necessary maintenance
or repairs before operating mower. If the mower
should happen to fail despite regular maintenance,
please call our customer helpline for advice.

BLADE SHARPENING

KEEP BLADE SHARP FOR BEST MOWER
PERFORMANCE.
Cutting area
(maximum)
With 2*20V/4.0Ah
batteries
Up to 500m *
2
Up to 250m *
2
EN
17