Checking/Replacing Battery Of The Remote Control - Num'axes CANICOM VOICE 200 Guía De Uso

•
−
Touch 1: is used to record or read message N°1
−
Touch 2: is used to record or read message N°2
−
Touch 3: is used to record or read message N°3
−
Touch 4: is used to record or read message N°4
To save the messages, your collar must be open. Unscrew the 4 screws from the battery cover and push it on the
side. With your finger, hold it on the side for the duration of the recording. Choose short orders that you are used
to using and keep the same intonation as usual. When recording, do not yell or force your voice. Leave the collar
on the table at a minimum distance of about 40 cm.
To save your first message, continuously press the N°1 touch. The LED of the collar will flash in purple and then
switch to fixed purple, release the N°1 touch: you can then speak and record your message. At the end of the
message, briefly press the N°1 touch. Make several recordings to find the optimum recording distance.
Do the same for the following messages (2 to 4).
To listen to your message, briefly press the N°1 touch, the collar will restore your message 1. Do the same
manipulation to listen to the following messages (2 to 4).
To delete a recorded message, do the same manipulation as to save a message, continuously press the message
touch N°1 until the LED turns to fixed purple. Do this handling in a very quiet environment. Do not talk until the
recording is complete.
•
Adjustment of the loudspeaker volume
You can adjust the loudspeaker volume on the collar. Keep in mind that the loudspeaker will be placed near your
animal's ears. It is not necessary to adjust the sound volume to the maximum, a dog has much more developed
hearing than man.
Turn it on, then position the remote on the symbol at the back of your collar. The LED then changes to fixed blue
and the sound beeps scroll as long as you leave your remote in contact with the symbol. Remove your remote as
soon as you reach the desired sound volume.
Diagram. 5
Adjustment of the loudspeaker volume
At the back of the collar: location
to adjust the loudspeaker volume.
•

Checking/replacing battery of the remote control

To check the condition of the battery, press one of the buttons on your remote and observe the LED located on his
front.
- If the LED is green, the battery is still charged.
- If the LED is red, the battery is weak and you need to replace it.
Guide d'utilisation CANICOM Voice – indice B
buttons: messages
➢ Save a message to:
➢ Listen to the message you just saved:
➢
To delete your message:
Approach until coming in contact
these two areas to adjust the
loudspeaker volume.
18/56