Korona 10665 Manual De Instrucciones página 16

- Press the HOUR and MINUTE button to set the actual time.
- Once the actual time is set it will appear on the LED display
• Before making your first coffee, rinse the unit by filling the water tank (5) up to the Max. and operate it 2
-3 times without coffee. After that your coffee maker is ready for operation.
Attention: After each rinse cycle, the appliance has to be switched off for approx. 5 minutes, in
order to cool down.
Warning: Plastic bags are a danger to toddlers and babies, therefore keep them away to avoid
suffocation.
OPERAtION
The appliance allows you to brew coffee according to your taste and strength as well as to plan
ahead when you wish to enjoy it!
Brewing Coffee
Never open the appliance lid (1) during operation – hot water could evaporate – Danger of serious
burns!
Using a Paper Filter
1. Place the appliance on an even and heat resistant surface and connect it to a properly installed wall
socket.
2. O pen the appliance lid (1) and fill the water tank (5) with cold, fresh tap water. Use the carafe (6) to do
so. The markings on the carafe (6) indicate the desired number of cups. Do not exceed the Max. filling
level (12 cups)
3. I nsert a standard paper filter 1 x 4 into the removable filter holder (3). Make sure to fold the edges of the
paper filter and push it slightly down.
Note: When using a paper filter remove the permanent filter from the filter holder before inserting
the paper filter.
4. For each cup of coffee, use one leveled measuring spoon of grounded coffee (medium to fine). For
stronger or milder coffee, adjust the amount of coffee!
Press the STRENGHT button on the control panel if you wish to enjoy stronger coffee! The
respective indicator light lights up.
5. Close the appliance lid (1)
6. P lace the carafe (6) with its lid on into the appliance.
7. Press the ON/OFF button on the control panel to switch on the appliance. The respective indicator light
lights up, "12:00" appears on the LED display and the appliance start operation.
The brewing process can be interrupted at any time by pressing the ON/FF button on the control panel.
Once the unit is switched on again the appliance will continue with the brewing process.
Note: During the brewing process, the buttons PROGRAM, DELAY BREW, HOUR and MINUTE
are deactivated.
If you wish to have a cup of coffee before the brewing cycle is completed, remove the carafe (6) from the
appliance. Due to the automatic drip stop, dripping will automatically cease. Put the carafe (6) back within
30 seconds, dripping process will automatically resume.
16