CORBERO CF1PKMB48GLASS Manual Del Usuario página 21

1. The condenser and the compressor, located at the rear of the appliance, can
reach high temperatures during ordinary operation. Carry out the installation
according to this manual. An insufficient ventilation of the appliance will
impair its operation and will damage the appliance. Do not cover or block the
ventilation slats at any time
2. Do not touch the extremely cooled surfaces with wet or damp hands, because
your skin may stick on these surfaces.
1. When you move the appliance, hold it at its base and lift it carefully. Keep the
appliance in an upright position.
2. Do not tilt the appliance more than 45
3. If the appliance is transported in a horizontal position, some oil may flow from
the compressor into the refrigerant circuit.
4. Leave the appliance in an upright position for 4-6 hours before you switch it on
to ensure, that the oil has flowed back into the compressor.
5. Never use the door for moving the appliance as you will damage the hinges.
6. The appliance must be transported and installed by at least two persons .
7. When you unpack the appliance, you should take note of the position of every
part of the interior accessories in case you have to repack and transport it at a
later point of time.
8. Do not operate the appliance unless all components are installed properly.
9. Do not stand or lean on the base, the drawers, the doors etc of the appliance.
10. Do not put hot liquids or hot foodstuff into the appliance.
11. The air vents of the appliance or its built-in structure (if the appliance is
suitable for being built-in) must be completely open, unblocked and free of any
kind of dirt.
12. Condensation may form on the glass door,this is normal and is due to high
humidity of the surrounding area.
13. Body on both side of the cooler may gets warm or hot,it is normal due to
hot pipes embedded to prevent body from getting rusty.
CAUTION!
NOTICE
0 .
4