Residual Risks; Scope Of Delivery; Installation Sequence - RECARO 7217737 Instrucciones De Montaje

2.7. Residual risks

the supplied micro-encapsulated screws can break
or come loose if they are re-used several times. In
some circumstances, this can cause the racing shell to
become detached from its anchoring in the event of an
accident, and thus present a danger to life and physical
condition.
Use only the supplied micro-encapsulated screws
„
when installing the racing shell.
Use the supplied micro-encapsulated screws only
„
once.
Tighten all screws with the specified torque.
„
3. Installation
NotICE
the interplay between the racing shell and the adapter
is crucial to how the entire seat system behaves.
Mount the RECARO pro Racer Ultima 1.0 and
„
RECARO pro Racer Ultima Xl racing shells only
together with the independently tested RECARO
adapters 7217737.
Only this provides the necessary safety in motor
sports.
3.1. Positioning the racing shell in the vehicle
Select the most comfortable seat position for yourself
„
that is safest for driving the vehicle:
You must be able to completely hold the top edge of
the steering wheel without lifting yourself out of the
seat with your back.
Your knee must still be slightly angled when the clutch
or brake pedal is fully pressed.
Make sure that the restraint systems and the roll cage
„
are correctly installed (see the manufacturer's instal-
lation instructions).

3.2. Scope of delivery

Check the scope of delivery for completeness before
„
installation.
Racing shell (Figure A)
(1) Racing shell, 1 ea.
(2) Front seat cushion, 1 ea.
(3) Back seat cushion, 1 ea.
(4) Replaceable pads, 9 ea.
Adapter (Figure B)
Steel adapter 7217737
(5) Adapter, 2 ea.
(6) Washer, 13x20x2, 4 ea.
(7) Screw M12x25, 12.9, 4 ea.

3.3. Installation sequence

Refer to Page 3 for the associated drawings.
Mounting adapters in the vehicle
NotICE
the adapters must be secured in the vehicle and the
associated structural modifications to the vehicle must
be done in accordance with the stipulations of the re-
spective national motor sports association or of the
FIA and as per the applicable version of the regulations
that apply.
Mount the adapters in the vehicle using at least four
„
M10 screws, strength class 10.9.
tightening torque: 35 Nm.
Fixing the racing shell (Figure C)
1. position the racing shell between the adapters.
2. Fix the racing shell at the rear on the adapters with
the washer (6) and M12x25 screw (7).
When doing this, only tighten the screws hand-tight.
3. Fix the racing shell at the front on the adapters with
the washer (6) and M12x25 screw (7).
When doing this, only tighten the screws hand-tight.
Final mounting
tighten all 4 fastening screws M12x25 (7) with a tigh-
„
tening torque of 22 Nm +2/–3 Nm.
DANgER
Danger of serious injury if the racing shell beco-
mes detached from its anchoring.
Use only the supplied micro-encapsulated screws
„
when installing the racing shell.
Use the supplied micro-encapsulated screws only
„
once.
Tighten all screws with the specified torque.
„
7