Stand the pantry assembly with hardwood cap up
4.
in the cabinet locating the cap to directly cover the
plywood partition. (Fig 5)
With the hardwood cap resting on the
webs of the front metal brackets secure
the cap to the plywood using the
#8 x 2" screws provided. (Fig 5) NOTE:
Check panel is centered in the cabinet.
VIEW FROM REAR
OF CABINET
Attach magnetic bases to each
side of the plywood partition
2 7/8"
FIGURE 6
6.
Use 2" screws to attach the hardwood
cap to the plywood (5 locations)
5.
Attach the magnet latch base to each side of the
plywood partition using the screws provided 2 7/8"
from the top of the plywood partition to the top of
the magnetic base and flush with the back side of
the divider panel. (Fig 6)
Fig 6
Attach the magnetic catch plate to the top inside
corner of each of the swing out pantry units 1/4"
from the back face. (Fig 7)
Fig 7
FIGURE 7
Be sure panel is centered in cabinet
Hardwood cap rests on top of the
sheet metal bracket during installation
1/4"
10-0532-03G VS-40
FIGURE 5
Fig 5
